1 Inch Badge Machine w/ Graphic Punch & Badge Parts

These All-In-One 1 Inch Starter Packs are all you need to start making your own buttons, and to save money! These packs include:

* Tecre 1 Inch Badge Machine Model #100
* Tecre 1 Inch Graphic Punch Model #100

The Tecre Model #100 Badge Machine is an amazing machine, which can produce thousands upon thousands of 1 Inch badges, all with an extremely simple operation.

Here at The Badge Factory, we use this machine every day, and it never fails us. Maintenance is just a simple "spraying" of a household lubricant such as WD-40 around the joints every thousand or so badges, and the spring mechanism is so easy to use, anyone can do it!

To operate the machine, simply place the "Shell" inside the larger of the two dies, followed by your artwork, and on top of that place the plastic covering, called the "Mylar". Then simply rotate the die, place the "Collet" in the smaller of the two dies, clamp the first die down using the protected handle, roate the die again, clamp, and there you have it, a perfect 1 Inch Badge, every time!

Tecre Graphic Punches are the best, hands down, of all the graphic cutters out there. Sure, there are plenty of others floating around, but after making millions of badges ourselves, we have done the research!

This model of graphic punch is the #100 model, which is used to punch out graphics for 1 Inch badges, the machine that accompanies this cutter is the model #100 Badge Machine.

These graphic punches save you loads of time, and are the easiest to use out of the lot. Simply line your graphic up with the top hole, press the lever, and you are done! It is also entirely possible to cut more than one sheet at once, saving you even more time!

Trust us when we say these are the best on the market, as Australia's largest badge manufacturer, we would not use anything else. We love this product, and know you will be extremely happy with it too!

How to cut a graphic using a Manual Graphic Punch



1. Insert graphic strip into graphic punch and center the graphic in the hole.
2. Push handle down until the punch goes all the way through the graphic.
3. Remove the cut graphic and place to the side.
4. Pull the graphic strip through, center the next graphic, and repeat steps 2 and 3.

1 Inch Complete Parts Sets include: * Shells * Collets * Spring Lock Pins * Mylar (Plastic Cover)